Radon mitigation is essential to reducing your family’s health risks. The question often asked by concerned New Yorkers is whether or not the acceptable level of radon in their homes is the same as the level that is present when the home was built. When purchasing a new home, homeowners are often not told the true facts about radon gas and the impact it has on their health. This can be very dangerous for people who have just begun living in the home.
Radon enters the home through the cracks in the foundation and floor, which can be as small as a fraction of an inch. It seeps into the home through cracks in the basement walls, the unfinished basement floor and even through pipes that are not considered part of the house structure by the home owner. Radon gas can be tracked throughout a home, especially in the basement areas, and can build up to very dangerous levels over time. Radon is so dangerous, in fact, that some parts of the United States have imposed regulations to protect homebuyers from the dangers of radon.
New York State has set an acceptable radon level for homes to be sold. These levels have been determined based on scientific research, but the State has also done studies to determine what these levels would be if the home was built according to strict radon mitigation techniques. Radon mitigation techniques include sealing cracks in the basement walls and floors, which will prevent radon gas from leaking into the home. New York has established a Radon Control Rating System, which rates different radon mitigation methods. In homes located in high-radon zones, the radon control system will be tested periodically to ensure that the system is performing adequately.
Radon abatement techniques also include sealing cracks around the exterior of the house and installing weather-stripping on the outside of windows. The radon abatement professional will also perform an air quality inspection of the outside of the home and inside to determine the exact amount of radon present. The radon level can be measured using specially made radiation detectors. New York City and New York State officials recommend that no more than 0.01 milligrams per square foot of indoor air should be present in any room. These levels are considered safe for most people.
Radon levels can be reduced with the use of radon abatement or mitigation systems. These techniques are commonly used in homes located near mines or other sources of radon. Radon abatement uses air ducts and fans to move the radon through the home, while mitigation uses trenches with spaces between them to capture radon. Both techniques can effectively remove or reduce radon in a home. There are many factors to consider when determining the best course of action to take in terms of reducing radon levels in a home.
New York City has a team of professionals who are qualified to evaluate radon abatement and mitigation services. In New York City, consultants are often available to walk the homeowner through the process, and often the consultants are free to give advice. The New York State Health Department is also a resource for additional information regarding radon mitigation. A radon mitigation specialist is not only trained in assessing the acceptable level of radon in a home, he/she is also trained in removing radon and repairing leaking radon pipelines. When choosing a radon mitigation service, it is important to make sure the agency is licensed, bonded and insured.
It is important to learn how to be Asbestos safe. Not only does it cause health problems, but the more you know about Asbestos and its effects the better off you will be. The more you know about Asbestos and its harmful affects the more likely you are to know how to be Asbestos safe. In this article we will cover what you need to know about Asbestos. We will also cover why it is important to have an accurate radon testing and abatement inspection done by a qualified professional.
Radon is one of the most dangerous and insidious contaminants that can find its way into your home. It is the slowest growing naturally occurring substance found in the earth. The gas that radon creates is a colorless, odorless and tasteless. It creeps into a home through the cracks and crevices, compromising the home’s air quality.
You may not know it, but you could have Asbestos in your home at any time. It was used in building materials long before it was officially banned. During the 1970s, high level engineers and construction workers were subjected to Asbestos dust without the knowledge or consent of safety specialists. This resulted in significant lung cancer rates among employees who worked with Asbestos.
The legal requirements for safe work environments do not always protect employees from the dangers of Asbestos dust and Asbestos poisoning. For example, laws regarding Asbestos exposure require companies to have a “safe working environment” clause. As long as there are no health and safety regulations in place concerning Asbestos contamination, an employer is not required to monitor the workplace for Asbestosis. The only way an employee is tested for Asbestosis is through a chest x-ray or through special procedures approved by OSHA.
Inhaling large amounts of Asbestos dust will cause irritation to the lungs. The body will attempt to expel the Asbestos particles from the lungs via exhalation. The body will build up a protective mucus over the lungs that Asbestos particles will adhere to. Over time, this mucus will decrease in thickness and become sticky. As the Asbestos particles begin to become trapped, they will cling to this sticky mucus and slowly drift down into the pleural sacs and eventually into the lungs.
The only way to stay Asbestos safe and avoid being exposed to its deadly properties is to be tested upon initial employment. A lung scan will identify if you have been exposed to high levels of Asbestos. Special devices called air monitors will allow you to be monitored while at work. Knowing how to be Asbestos safe during employment can provide peace of mind during your career.